 |
CA's and Epoxies |  Click to visit the Bob Smith Industries Web Site |
|
CA's and Epoxies | Click to visit the Bob Smith Industries Web Site |
Accelerator & Debonder
INSTA-SET Accelerators |
||||||||||||
 |
INSTA-SET> is a catalyst which acts as an accelerator that allows CA'S to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET significantly enhances a joint's strength. For difficult to bond materials, INSTA-SET can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CA'S strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.
|
|||||||||||
|
||||||||||||
| UN-CURE Debonder |
||||||||
 |
UN-CURE debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers, once unstuck, use acetone to clean off softened CA, then wash off with soap and water. |
|||||||
|
||||||||
Back to the CA & Epoxy Main Page
Email to sales@nscalesupply.com
Back To Catalog Page
© Copyright 1997, 1999 by Solution Development, Inc.