Switch-it MK2 -- Controls 2 Tortoise Switch Machines (Jumperless Programming, On-Board Display)

Features of the Switch-It Mk2:

• Easy programming with no jumpers. LED on board display.
  
• Control for 2 Tortoise switch machines
  
• Remembers the position of switch during power outages
  
• Supports the full range of DCC accessory addresses (1-2044)
  
• Easy address programming, no need to connect it to programming track
  
• Onboard push button connections for local control panel operation
  
• Simple hook up, 2 wires to the track, 2 wires to each switch machine

P114 - Power Supply for Power Cab (NCE--25; Sold Separately)

US approved power supply suitable for Power Cab and other applications. Replacement power supply for the Power Cab kit. Using ANY other power supply for the Power Cab is not recommended and will void the Power Cab factory warranty. This plugs into the back of panels such as the PCP (Power Cab Panel) the newer UTP and UTP-CAT5.

AR10 Auto Reverser with built in Circuit Breaker

Features of the AR10:

• Automatically controls the polarity of DCC reverse loops
  
• Provides short circuit protection for loop
  
• Ready to run without any programming
  
• Trip current adjustable 1 to 10 Amps
  
• Easy hookup using screw terminals, no soldering
  
• Solid state design provides silent, reliable operation
  
• Status indication LED
  
• Additional output for remote LED
  
• Automatic or manual reset after short circuit shutdown
  
• Adjustable short circuit response time

P519 5amp 19VDC Power Supply -- NOT FOR USE WITH SB5, DB5, or PB5 BOOSTERS.

The P519 is a 19 Volt DC, 4.74 amps, 90 Watt with US power cord. Power supply suitable for use with the following NCE products: PH5 (5 Amp system) and PB5a Booster. Replaces the P515 NCE-215.

Note: For PowerPro (5 Amp system) PB105 booster. For use with these older NCE systems Customer should cut off the round connector, then strip the cable to expose the two wires that connect to your system's screw terminals. Input is not polarity sensitive.
NOT FOR USE WITH SB5, DB5 or PB5 BOOSTERS.