The ideal power supply for the SwitchWright, this unit is well-regulated and current protected. The unit has a barrel connector that fits the adapter below or you can cut it off and strip the wires. It can support about 30 SwitchWright switch machines. 115V (US) input only (not suitable for 230V).

Input: 90-132 VAC 60Hz
Output: 5VDC @ 4A
Specifications/Features: Switching plug supply with overvoltage & current limit protection. Non-Polarized 2 blade input. 6ft output cord with 10mm X 5.5/2.1mm ID Right Angle coaxial plug Center +. UL/canada/usa/listed. RoHS compliant .
H: 3-3/8" W: 1-1/2" T: 2-1/4" WT: .3

12V 5A Power Supply for Accessory Bus Use

12V 5A 60W switching power supply. Best for powering the Octo III. This unit will power up to 4 Octo IIIs fully loaded with servos. Plug size is 5.5/2.1 mm. Power supply comes with a US 110V plug. By swapping the power cord can be used with 100-240V~50/60Hz power. If you don't want cut and strip the wire ends use the power jack to screw terminal adapter below.

16V 4.5A Power Supply for Track Power Use

16V 4.5A 72W switching power supply - best for track power. Delivers about 15 V to track when used with our booster above. Plug size is 5.5/2.1 mm. Power supply comes with a US 110V plug. By swapping the power cord can be used with 100-240V~50/60Hz power. If you add the power jack to screw terminal adapter below you can use this as a general purpose power 16V supply. Peak-to-peak output from DCC booster will be about 14.5-15V varying with the load.

This adapter mates with the above two power supplies to make them easy to hook up to wires using the screw terminals. Jack size is 5.5/2.1 mm. Plus and minus terminals are marked. Price is for one adapter - picture shows two to illustrate both ends.

This adapter mates with the DCC boster power jack in order to hook up your own power supply using the screw terminals. Plug size is 5.5/2.1 mm. Plus and minus terminals are marked. Price is for one adapter - picture shows two to illustrate both ends.